Where to purchase
12 Volt Dimmers
> 12 volt Dimmer (9-30v dc)- Low voltage rotary dimmer, 5 amps, model EF1206
12 - 24 volt Low voltage dimmer - LED Dimmer
12 volt Dimmer (9-30v dc)- Low voltage rotary dimmer, 5 amps, model EF1206
Part of our versatile Color Collection.
Choose from 5 bezel/knob colors.
Colors can be coordinated to match various light fixtures.
OD 2.36" (60mm) square
2.125" (54mm) cut-out diameter
1.32" (33mm) recessed depth
0.35" (9mm) profile
12 volt DC - 24 Volt DC (9-30 volt DC range)
60 watts at 12v DC (5 amps max)
120 watts at 24v DC (5 amps max)
PWM (Pulse width modulated)
Knob and Bezel: Chrome, Gold, Matt Silver, Sandstone, White.
Dry location only
Rotary dimmer, click on -off
Versatile dimmer for use with 12 volt incandescent, halogen, Xenon and LED lights.
Features/Options [+ adds to price if indicated]
Bezel / Knob Color
Chromed (plastic) [+$5.00]
Gold (plastic) [+$5.00]
Matt Silver (plastic) [+$5.00]
Silver Sand [+$5.00]
Add to Cart
Add to Wish List
Add to Gift Registry
Email a friend
LED Lumens to Watts Comparison:
Our 12 volt dimmers - 24 volt dimmers can be used for low wattage 12 volt DC and 24 volt DC incandescent, Halogen, Xenon or LED lights, including the FriLight and the 12 volt lights with Bee Green LED Bulbs we offer on our web site.
NOTE: This dimmer is only for use with resistive loads, and so is NOT for use as a motor control.
This 4 wire 12 volt dimmer is great for New Installations & Retrofits. It can replace an existing switch provided you have access to both power + and - (install inline between the power source and the lights; and the dimmer must be connected to - ground). Refer to the Wiring Diagram in the images below.
12v-24v Dimmer ef1206 Mounting Suggestions:
Make a cutout for the 2.125" diameter housing directly into your wall panel.
Seat the housing into the wall cutout and mark the wall for 4 pilot holes to match the housing corner screw hole pattern. Remove the housing. Drill the pilot holes in the wall.
Wire the dimmer to your wiring in the wall.
Seat the dimmer housing into the wall cutout. Seat the dimmer guts in the housing, pushing the excess wire into the wall.
Install 4 mounting screws to hold the housing to the wall, and snap the bezel into place (this hides the mounting screws).
To Retrofit into an existing switch housing:
Mount the Dimmer ef1206 onto a blank wall plate that fits onto your existing switch housing.
Note: Standard Blank Wall plates that fit standard residential style electrical switch boxes are available in various colors from hardware stores and electrical suppliers.
Click here for PDF installation instructions.
Recently Viewed Items